Masonry Magazine February 1993 Page. 58

Masonry Magazine February 1993 Page. 58

Masonry Magazine February 1993 Page. 58

inches, and not less than one times the footing projection unless reinforced. Example: For a 15" x 20" masonry unit excavate a hole approximately 4' x 5' x 4' deep. If a form were constructed to the dimensions 24" x 32" the footing projection would be 6" and the thickness would be 9". (Refer to detail A).

Allow the concrete to cure for at least 24 hours before beginning construction of the chimney.


Base Section

A cleanout opening must be provided in all chimney flues. The cleanout must be equipped with a non-combustible door and frame which will remain tightly closed when not in use.

Begin the masonry units at the top of the footer and place the cleanout in the first two units completely above ground. Fill in the first four and one half masonry units with a prepared gravel mix concrete to bring the solid base closer to ground level, or fill the first four units with compacted gravel and place a 4" solid concrete base on which to begin the flues. Prepare a bed of refractory cement on top of the concrete to receive the first section of the flue liner. This will create the proper base and keep the flue liner in place. Mortar for flue linings must be a refractory cement. (Refer to detail A).


Flue Liners

Every chimney designed to service a wood burning stove must have a fire clay flue lining with a minimum thickness of 8 in. The flue lining should provide continuous protection of the surrounding masonry throughout the chimney. Flue liners should begin at the base of the chimney and must be offset so that their joints do not occur at the same place as the joints between the masonry units. Flue linings should be capable of


AL ISBERNER, P.E. CONSULTING MATERIALS ENGINEER
(608) 742-5684
1050 Thompson Street, P.O. Box 486
Portage, Wisconsin 53901-0486
Services Available:
Contract Document Review
Quality Assurance Assistance
Preventive Maintenance Plans
Laboratory Evaluation
Quality Control Assistance
Litigation/Expert Witness
Performance Evaluations and Inspections of Masonry, Concrete and Plaster/Stucco Structures


MASONRY
CONCRETE
PLASTER/STUCCO


58 MASONRY-JANUARY/FEBRUARY, 1993


Masonry Magazine December 2012 Page. 1
December 2012

December 2012

MASON RY
The Voice of the Masonry Hyduser
Volume 51, Number 12

Fireplaces

Old

INSIDE
Modular Stages
Waterproofing
Refractory Mortar

Visit us online at:
www.masoncontracto

Masonry Magazine December 2012 Page. 2
December 2012

Standing
The Test of Time
Units M100-4, M100-5, M100-6
Purchase date: January 1988
Status: Still fully functional

"After more than 23 years of operation, all my Hydro Mobile units still deliver full return and I still get the sa

Masonry Magazine December 2012 Page. 3
December 2012

Performance and Economy

THROUGH THICK AND THIN™

Everyone wants more from less. ENERSHIELD® gives you exactly that. Premium polymer-based formulations allow optimized application thickness on sheathing and masonry, for fast, easy instal

Masonry Magazine December 2012 Page. 4
December 2012

JOIN THE MCAA AT WOC 2013
GET $1,500 IN SUPPLIES

BECOME A MEMBER AND RECEIVE OVER $1,500 IN MATERIALS AND SUPPLIES*
JOIN THE MCAA DURING THE 2013 WORLD OF CONCRETE/WORLD OF MASONRY IN LAS VEGAS

When you become a member of the M