Study Shows Brick Veneer Driest of Exterior Walls Tested

Words: Brickcraft N/A LastA new study by the NAHB Research Center comparing moisture resistance among typical residential exteriors evaluated brick veneer as the highest in moisture resistance and dryness. As the trend toward lighter, tighter building methods continues to raise moisture concerns, the study aimed to determine how exterior cladding can impact the moisture content of the wooden components in the wall construction. Of the eight wall systems tested-accounting for approximately 90% of the cladding systems used today-brick veneer wall assemblies performed the best overall in controlling moisture.

"The lab report's findings on brick's superior moisture resistance are extremely significant," notes J. Gregg Borchelt, President & CEO of the Brick Industry Association (BIA) at www.gobrick.com. BIA funded the study along with the U.S. Department of Agriculture's Forest Products Laboratory and the U.S. Department of Housing and Urban Development. "Builders will want to choose brick if they wish to provide their customers the protection of a superior wall system-instead of one that is just 'good enough.'"

Modern construction practices to increase comfort and energy efficiency have resulted in tight walls that are highly insulated and sealed against air filtration. When moisture is not sufficiently controlled, risks increase dramatically for mold growth, wood rot and infestation by insects, reduced efficiency of insulation and corrosion of fasteners. The report at www.gobrick.com/nahbrcreport attributes the lower moisture content in the wood components to brick's inherent thermal mass properties, the one-inch air space in the brick veneer wall and the increased thermal absorption of the test brick's red color.

Moisture performance values were collected at regular intervals from key components within a pair of wall assemblies constructed with eight different cladding types. Each wall assembly consisted of interior gypsum board, wood studs with fiberglass insulation between the studs, sheathed with either OSB or plywood and clad with brick veneer, vinyl siding, fiber cement, manufactured stone or stucco and was then subjected to ambient weather conditions over a one-year period. A portion of water resistant barrier was compromised and the wall assembly behind it subjected to a daily water injection over a five-day period to evaluate its ability to dry after a leak.
About: Featured
 0
Masonry Mortar: The Right Type for the Job
May 2025

When it comes to masonry construction, mortar is much more than “glue” that holds everything together — it’s a critical component of wall performance, longevity, and aesthetics. It can “make it or break it”. Whether you’re laying a foundation CMU wall or

Garen Graves
Featured MAP Partner
Mortar
Read More
MASONRY STRONG Podcast, Episode 20 Recap: Mark Kemp, Superior Masonry
May 2025

Justin Stengel
Read More
How It’s Made: Clay Thin Brick
May 2025

Clay thin brick is a versatile alternative to traditional full brick. It comes in numerous colors and styles and offers something for every design preference. Thanks to the lighter weight, it is designed to reach spaces full brick cannot. From floors to c

Allison Goley
Featured MAP Partner
Read More
Bonding with Masonry 2025: Q1
May 2025

This issue’s questions come from an Architect and a Mason Contractor. What questions do you have? Send them to info@masonrymagazine.com, attention Technical Talk. Q. An Architect asks how to create a narrow masonry pier between openings. Is there a min

David Biggs
Featured
Read More